![]() Select “Install the software automatically (Recommended)” then click If you are prompted with the choice, pick “No, Not This Time” when asked if you want to connect to the Internet to search for drivers. If you are using XP or W2000, click on the Found New Hardware message and the Found New Hardware Wizard should start up. The drivers many install automatically in Windows 7 or Vista. Interface, a message like this should pop up: If you are using a Serial Interface then you can proceed to step #4. But looking for suggestions before I bite the bullet on full version with the Ross tech cable. I don’t mind being out $10.00 for the cable. ![]() I have tried uninstalling, and reinstalling multiple times. Ive tried doing this while connected to my s4. Read golden rule above? Launch VCDS software from Start Menu. Golden Rule: Must disconnect from internet everytime before launching VCDS, else will say 'Interface not found'. ![]() STEP 3: Disable Internet & Launch VCDS Software. How to fix a failed firmware update (flashing red LEDs) on a current generation Ross-Tech® VCDS® interface - the HEX-V2® and HEX-NET®.Brought to you by Genda. If your PC is further from the vehicle’s diagnostic port than 6 feet,Ĭonnect an approved Extension Cable between the PC and the Interface. The last thing i have tryed is to go into the windows firewall and added the VCDS program to the list and click allow, i think i had this issue with VCDS lite but it was long time ago now so can't remember.This article show a guide on how to configure VCDS diagnostic cable for you laptopĬonnect the USB end of your USB Interface or the Serial end of your Serial Interface to the correct port on your PC. I have tryed lot of things suggested on various sites but nothing worked. ![]() I have re-installed the usb driver as Ross-Tech site tells me to with just the cable plugged into the laptop and everything is ok. Went to scan a car last night and it started the scan then half way through the scan it started doing the pop up thing (Yellow Sheild) and would'nt connect. Un-installed everything and re-installed it few times then it was working as it should. Went to log yesterday and when i plugged the cable into the car the laptop had pop up thingy (Yellow Sheild) saying USB not recognised or somthing similar an with the cable plugged in it was making the noise when you plug a usb in but it was like it was switching on and off I have Genuine Ross-Tech Hex-Can-Usb, installed it all and everything worked fine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |